0.21" (5.3mm) D x 0.7874" (20mm) x 1.4" (35mm) [frame]
300 - 20kHz
Give your train the best in sound by installing a compatible HiLine™ speaker with your HiLine™ sound system. This speaker is on the smaller size and is best suited for HO and larger scales.
Installation Instructions
Solder wires to the pads on the back of the speaker. For HiLine™ sound systems, use the wires from the two pin connector harness, designated for the speaker, to the pads. (Two pin connectors are included with all HiLine™ sound system but can also be purchased separately. See item #222 or #224)
Create an enclosure for the speaker. This is best done with thick cardboard or plastic. Typically a circular hole is cut from cardboard and the edges of the speaker are glued to the cardboard so that the
outside of the cone shows through the hole. Then the cardboard is cut to fit within the locomotive and glued in place.
Connect the two pin harness to the speaker output of the sound system. (See your sound system instructions as the ports vary between systems)
Technical Specifications
Item Number
215
System Compatibility
This speaker is fully compatible with all HiLine™ sound systems as well as any prior Dallee sound system.
Decibel output @ 1 watt
86db
Frequency Response
590 Hz - 20 kHz
Power Handling (RMS)
1 Watt RMS, 1.5 Peak
Impedance
8 Ohm
Diaphragm Material
Plastic
Physical Dimensions
0.21" (5.3mm) D x 0.7874" (20mm) x 1.4" (35mm) [frame]
