Log In | Cart
1.41" Round 8 Ohm Speaker - 1W, 2W Peak - Dallee Electronics

1.41" Round 8 Ohm Speaker - 1W, 2W Peak

Item Number: #231
  • 77db
  • 300Hz - 20kHz
  • 1.41" diamater x 0.23" deep
  • Mylar Diaphram - water resistant

Give your train the best in sound by installing a compatible HiLine™ speaker with your HiLine™ sound system. This excellent speaker is best suited for S, O and larger scales.

Installation Instructions

  1. Solder wires to the pads on the back of the speaker. For HiLine™ sound systems, use the wires from the two pin connector harness, designated for the speaker, to the pads. (Two pin connectors are included with all HiLine™ sound system but can also be purchased separately. See item #222 or #224)
  2. Create an enclosure for the speaker. This is best done with thick cardboard or plastic. Typically a circular hole is cut from cardboard and the edges of the speaker are glued to the cardboard so that the outside of the cone shows through the hole. Then the cardboard is cut to fit within the locomotive and glued in place.
  3. Connect the two pin harness to the speaker output of the sound system. (See your sound system instructions as the ports vary between systems)

Technical Specifications

Item Number 231
System Compatibility This speaker is fully compatible with all HiLine™ sound systems as well as any prior Dallee sound system.
Decibel output @ 1 watt 77db
Frequency Response 300 Hz - 20 kHz
Power Handling (RMS) 1 Watt RMS, 2 Peak
Impedance 8 Ohm
Diaphragm Material Mylar
Magnet Type Samarium Cobalt
Physical Dimensions 1.41 Inch Diameter x 0.23 Inches Deep

All Content Copyright © 1976-2024 Dallee Electronics, Inc.

Privacy Policy and Conditions