Log In | Cart
6" x 2.2", 8 ohm, oval speaker - 13W, 18W Peak - Dallee Electronics

6" x 2.2", 8 ohm, oval speaker - 13W, 18W Peak

Item Number: #217
  • 95 dB
  • 30Hz-20kHz
  • 6" x 2.2" x 2" Depth

Give your train the best in sound by installing a compatible HiLine™ speaker with your HiLine™ sound system. This speaker perfectly reproduces the deep low frequencies parts of any diesel locomotive exceptionally well. This speaker fits inside some G engines, ride on engines, and is perfect for a stationary setup.

Installation Instructions

  1. Solder wires to the tabs on the back of the speaker. For HiLine™ sound systems, use the wires from the two pin connector harness, designated for the speaker, to the pads. (Two pin connectors are included with all HiLine™ sound system but can also be purchased separately. See item #222 or #224)
  2. Create an enclosure for the speaker. This is best done with thick cardboard or plastic. Typically a circular hole is cut from cardboard and the edges of the speaker are glued to the cardboard so that the outside of the cone shows through the hole. Then the cardboard is cut to fit within the locomotive and glued in place.
  3. Connect the two pin harness to the speaker output of the sound system. (See your sound system instructions as the ports vary between systems)

Technical Specifications

Item Number 217
System Compatibility This speaker is fully compatible with all HiLine™ sound systems as well as any prior Dallee sound system.
Decibel output @ 1 watt 95db
Frequency Response 30 Hz - 20 kHz
Power Handling (RMS) 13 Watt RMS, 18 Peak
Impedance 8 Ohm
Diaphragm Material Paper
Physical Dimensions 6 Inches long x 2.2 Inches wide x 2 Inches Deep

All Content Copyright © 1976-2023 Dallee Electronics, Inc.

Privacy Policy and Conditions