Log In | Cart
Grade Crossing Flasher Controller - Dallee Electronics

Grade Crossing Flasher Controller

$29.95
Item Number: #367
  • Alternate Flashing Light Controller
  • Control Grade Crossing Lights
  • Operates Lamps & LED's
  • use 1 output for a STOBE effect
  • 1.5" x 2" footprint

The Dallee Grade Crossing Light Flasher controller makes it easy to alternately blink two lights just like a regular grade crossing. The flash speed can be controlled by turning a dial on the board. By wiring just 1 lamp, a strobe effect, blinking light, can be accomplished.


Dallee Electronics Crossbuck Flasher

Flasher demonstration with AF crossbuck and history of flasher's with 3 rail trains

Installation Instructions

  1. Route power from a 6-20 volt power supply to the Common and Input terminals on the flasher controller (if DC, use the Common terminal for the negative lead).
  2. Link the common wires from each light and attach them to the common terminal on the flasher.
  3. Connect the remaining power wire for each light to the lamp one and lamp two terminals (one in each).
Grade Crossing Flasher Control Module Wire Diagram


Three Rail Detection

Three rail detection is provided easily by using the outer rails to complete the common wire in the circuit.
Grade Crossing Flasher with Three Rail Detection


Two or Three Rail Detection

Activating the flasher on a two rail layout requires the use of a detector, such as the Trak-DT or Trak-DTT.
This method can also be used with 3 rail operation. The upper rail would be the center rail or both outside rails.
.
Grade Crossing Flasher with Detection.


This drawing shows operating a crossing gate with a DC switch motor.
Grade Crossing Flasher with Detection and optional crossing gate drive.


Activating the flasher on a two or 3 rail layout using the Trak-DTRL.
Grade Crossing Flasher with Trak_DTRL.


Activating the flasher on a two or 3 rail layout using the Trak-DTRL.
Grade Crossing Flasher with Trak_DTRL and optional crossing gate drive.


Technical Specifications

Item Number 367
Instructions Grade Crossing Flasher #367 Full Instructions
Grade Crossing Flasher Application and Examples
Grade Crossing Flasher Application using Lionel 153IR
Flash Speed (typical) 0.56 Hz - 2.5 Hz (half a second to two and a half times a second)
System Compatibility AC or DC Power
Current Handling 2.5 Amps per output
Power Input 6-20 Volts AC 6-25 Volts DC



All Content Copyright © 1976-2025 Dallee Electronics, Inc.

Privacy Policy and Conditions